weird plasticky goo in my needle valve

[frostr6]

I just installed that same pump, and no leaks, but I feel like I've seen posts about some folks having trouble getting a good seal on the inlet or outlet...

[frostr6]

I haven't seen a source for that version of the horn pad, I'd love to have an extra for my '69, it makes me a little nervous every time I have to remove...

[frostr6]

I use Track Addict on my iphone. I know there are others, but I haven’t tried any others for comparison, and this is pretty easy to use.

[frostr6]

I replaced the fuel filter as part of the initial troubleshooting, but it doesn’t seem clogged, I can easily blow though it. I didn’t take the new...

[frostr6]

It's been a rough week with the TR6. Last Sunday I went for a test drive after adjusting the temperature compensators (trying to fine-tune the idle),...

[frostr6]

Bummer, I just saw this and it's sold out. This was a great deal, I'll have to keep an eye out for this again.

[frostr6]

I did a similar thing with an old Volvo, replacing some suspension bushings with rubber pieces cut from the sole of some old Converse sneakers. I drove...

[frostr6]

I looked up the part numbers on this website:
https://kirbysbrakebleeders.ecrater....speed-bleeders

then searched...

When I checked speed bleeders they didn't show TR6. What model application did you use?

[frostr6]

I 'cheated' the last time I bled the brakes and changed all the bleeder valves out for speed bleeders, and the clutch too. Only about $35 to do the whole...

[frostr6]

I was asking about this recently too, I like that it bolts right up, saves the expense of a hub and uses the original horn parts. It sounds like Anthony...

[frostr6]

Reposting this in the right place:

I took my car to the local hill climb last weekend, my first time driving there, and had a great time....

[frostr6]

In my case the gaps weren't great anyway, and ended up a little improved after the replacement. I did end up changing the number of shims in a couple...

[frostr6]

I love watching the '60s saloon races with a mix of Jaguars, Minis, Austins, and that giant Ford Thunderbird, and the pre-and post-war races with the...

[frostr6]

I replaced all of my rubber body mounts earlier this year, it's definitely possible, you just need to loosen or remove all of the bolts and jack up just...

[frostr6]

I took my car to the local hill climb today, my first time driving there, and had a great time. The is video from my best run of the day - the GPS of...

[frostr6]

That looks terrific, and I can understand taking inspiration from that GT6 restomod project, they seem to have a similar engineering bent that you bring...

[frostr6]

I don't know if this store is still active, but you can see part numbers for the stock parts here:
https://kirbysbrakebleeders.ecrater....e-clu...

[frostr6]

Welcome! A brush paint job would look fine, the block and head are rough enough castings nobody will see any brush marks. if you can't find crushable...

[frostr6]

Good luck! What color are you going with?