That's in pretty decent shape. Very nice find, Lou.
The Road & Track road tests of the time placed the acceleration of the 4 cylinder...
SapphireBlue72
Mitty Graduate
Last Activity: Today, 10:48 AM
Joined: 04-18-2012
Location: York, PA
-
I'm not absolutely sure this is the problem, but to me this says "air in the fluid/lines"....Leave a comment:
-
Beautiful work, Ed. Just sweet. The floors look fantastic, too.Leave a comment:
-
Most hub caps have a center hole which can be used for their removal.
If you have grease blocking the hole, then water & dirt are blocked...Leave a comment:
-
Obstacles for pets video
This is kind of funny if you have ever been around Golden Retrievers.
About 2 minutes entertainment.
https://www.youtube.com/watch... -
BRG TR250 PROJECT in OR
-
It worked for me, or I wouldn't recommend it. Get the lube as far towards the rear of the cylinder lock as can be reached.
Other lubing agents...Leave a comment:
-
Insert the tip of the syringe with synthetic grease into the ignition switch, as you would the key, then push in the piston to release a little grease....Last edited by SapphireBlue72; 07-04-2020, 02:50 PM. -
Want the cure?...here's the cure.
The problem is not grit, the problem is a lack of lubrication.
...Leave a comment:
-
Philstr6 (member here) has the Churchill tools. You could send him a PM to see if he can help....Leave a comment:
-
All that is necessary is the hose & clamps connecting the PCV with the 'T'.
A previous owner may have added a filter.
PCV is just...Last edited by SapphireBlue72; 07-03-2020, 06:34 PM.Leave a comment:
-
Contact Goodparts & ask what he/ they would recommend that you do to separate the parts.
You will likely get a satisfactory response;...Last edited by SapphireBlue72; 07-03-2020, 06:14 PM. -
If it got put together, it can be taken apart. That's the way I think about this stuff.
Maybe post a photo of the problem area.Leave a comment:
-
When I removed the grille to clean & repaint it, the fasteners on the paper radiator air director were not all matching, though the grille nuts &... -
Here's original look (1972 model), somewhat worn grille area that was cleaned & repainted flat black by small brush.
Flat or satin black paint...Leave a comment:
-
Hi Gordon,
Thank you for contributing to the maintenance of this outstanding website. It is expensive to pay for & maintain.
For an answer...Leave a comment:
-
It's not a bad idea to add a fuel cutoff switch before the carbs.
After a drive you can close the cutoff and let your carburetors run dry....Leave a comment:
-
With a 215 wide tire the outer edges of the that tire will not contribute to ground contact.
The TR6 was engineered for 165 to 185 tires...Leave a comment:
-
Might as well get a jump on it & send the Z-S carbs to poolboy for a refresh. Either now or later.
Don't toss the old water pump- they...Last edited by SapphireBlue72; 06-22-2020, 04:07 PM.Leave a comment:
-
Agree with Lou, but you might check TRF website/catalog to see if they offer anything like that.
Might be an owner added item to plug holes or add...Leave a comment:
No activity results to display
Leave a comment: