ZS Dashpot orientation question

[baws]

I wouldn't change them now Dave, if they've been that way for a while and work fine, then there's no reason to change them.
A few years ago, I...

[baws]

Spoiler alert: I think they did pass the audition.

[baws]

As far as I can remember, the original peadal box bolts in my 73 were unpainted.

[baws]

I know that the little raised mark on the outside edge of the carb body should line up with the corresponding raised mark on the dashpot. On both my ZS...

[baws]

Any shop with the proper tool can make a cable to any length desired. I've has custom lengths made for various reasons over the years. The length of the...

[baws]

Many happy returns!
(Really enjoy your vids BTW!)

[baws]

Cool! Great idea for the passenger side bullet. Right now I have a stick-on convex mirror on that side but it is the wrong size.
Thanks for the...

[baws]

That's a bummer Walt. Knock wood, I've had no issues with stuff coming accross the pond. If anything, products seem to arrive faster from the UK than...

[baws]

Recently I ordered a spin on filter kit from Moss in San Luis Obispo, formerly XK's Unlimited. Much to my dismay, the alloy adapter piece was not true...

[baws]

Check the door striker on the B post. There is some adjustment there.
It's normal to see some wear at the spot on the door corner in your first...

[baws]

As has been said, the plastic floats absorb fuel, even if there are no cracks or holes in it.
If left out in the open air, for a short time, a...

[baws]

The factory installed vinyl also covers 2 holes in the lower right and lower left, below the radio delete panel. Very handy for auxilliary switches for...

[baws]

Slightly off topic but still germain, I just purchased a spin on adapter kit for the E. When I ordered it from Moss (formerly XK'S Unlimited), I asked...

[baws]

The local all British club here normally holds their big meet in May but it has been resheduled for September partly because of Covid but mostly because...

[baws]

Try adjusting the latch mehanism for now until the new seal "beds in" Guv. The bonnet may stand proud of the rest of the body work for a while...

[baws]

Thanks for the offer Blue and I remember talking to you. See you at Dixon in September.

[baws]

Thanks guys, that helped.
The motor we are playing with is actually a "spare" and we remounted the existing timing gears, which had punch...

[baws]

I'm assisting a budy reassemble an engine and we are ready to reattach the timing gears and chain. We are unable to locate or borrow a degree wheel so...

[baws]

Everything you've done already eliminates all my first thoughts on a remedy. I'm betting Ken's diagnoses is correct....