Announcement
Collapse
No announcement yet.
Home
Collapse
-
No, unless your subscription has expired.
-
Ken
Can you advise why I am not authorized to open the "articles" file ? I am subscribed. Am I doing something wrong?
THanks...
-
Yeah..a longer bolt..one long enough for a full size "jam nut".
-
If you have a Bentley, you could follow the foolproof steps for new unmarked sprockets.
ENGINE chapter. Section 12.41.05 Steps 73 thru 87.
Leave a comment:
-
180 ? Before you do anything make sure that # 1 piston is TDC on the firing (compression) stroke with both valves 1 and 2 are closed.....
Piston...Last edited by poolboy; 05-30-2023, 04:34 PM.
Leave a comment:
-
Keeping an eye on the marks damper or your degree wheel card oscillate the crankshaft clockwise and counter clock until you can measure equal lash on...
Leave a comment:
-
I don't use it in that application...but if you are going to use a thread locker near the exhaust manifold, you may not have very many choices.
...
- Likes 2
Leave a comment:
-
-
I followed Len Renkenberger's recommendation to use 2 gaskets that he made in his "SIX TECH" manual, Bruce.
When he wrote that manual...
- Likes 1
Leave a comment:
-
Do you mean camshaft not crankshaft, Anthony ?
If so you can check that with a fully assembled engine if you have a stock cam shaft or even a non-stock...
- Likes 1
Leave a comment:
-
I like that idea...I had a bad TRF green wire myself...but if your wire (TRF or not) isn't bad then do a compression test and see how that cylinder compares...
- Likes 2
Leave a comment:
-
This is the way the slave cylinder is supposed to be mounted ....and with the bleed nipple higher than the red hose... a tilted oil filter is just fine,...
Leave a comment:
-
Nice collection...I use that same trap under the sink in Winter with a lump of peanut butter.
-
I'm going try to keep an open mind, but it's going to have to have Jim Herter (RRR) come out and say that there is an error in the schematic in the Dan...
Leave a comment:
-
I use that Honda product a lot on all our vehicles..... as a cleaner and detailer between paste waxing..It's a great product as far as I'm concerned
- Likes 1
Leave a comment:
-
It is a nice car, guys, .....despite those big SU carbs..
Kevin turned the keys over to Lou at the St. Louis TRials....I even went along as a...
- Likes 2
Leave a comment:
-
1200 rpms kind of sounds like what you get if the Throttle Bypass Valve is open at idle...that is if the TBV diaphragm is still fresh and not old and...
- Likes 2
Leave a comment:
-
Are you confusing the Throttle Bypass Valves for the Idle Trim Screw ?
Leave a comment:
-
When you retarded the timing to 10 BTDC how did the manifold vacuum react to that move, Charlie ?
Leave a comment:
-
Moss may eventually get around to selling them.
They aren't listed in the originators online catalog for the TRiumph cars; but they do have them..you...Last edited by poolboy; 05-09-2023, 11:33 AM.
- Likes 1
Leave a comment:
No activity results to display
Show More
Leave a comment: